Lindell Audio LINTEC Porgram EQ

Legendary EQ in modern solid-state technology:

The Lindell Audio LiNTEC Vintage Program Equaliser is constructed as a solid-state design in order to utilise the essential advantages over tube circuits: The transients are reproduced accurately and concisely with a slightly soft, creamy and punchy character. The noise floor is also significantly reduced. The very low manufacturing tolerances allow the use of any two LiNTEC equalisers as a stereo setup - each pair is a matched pair. In addition, maintenance effort and costs are reduced in the long term as no tubes need to be replaced.

Noble sound profile and low-end trick

The classic sound character of the LiNTEC Vintage Program Equaliser from Lindell Audio lends tracks genuine vintage charm. The typical warm and harmonious sound of a famous equaliser has been integrated into the circuit design to give modern productions a vintage flair if required. The highlight: this effect is retained even when the EQ is set flat. The LiNTEC Vintage Program Equaliser is also suitable for using a tried and tested low-end trick: By simultaneously boosting and attenuating low frequencies, a unique filter curve is produced that creates a very special sound and has already helped a number of songs to success.

Vintage workflow with gridded pots

The Lindell Audio LiNTEC Vintage Program Equaliser is equipped with a classic control panel: Boost and Cut are available for low and high frequencies respectively to boost or cut the respective frequency. Separate boost and cut frequencies can be set for the high frequencies. Both treble bands share a bandwidth control. The rasterised potentiometers enable simple and precise stereo adjustment as well as quick restoration of previous settings. A prominent bypass switch is used for A/B comparison. A large VU meter allows the signal to be levelled and can be adjusted on the rear panel. The output level can also be adjusted there.