Skip to main content Skip to search Skip to main navigation
Go to homepage
DPA ST2011A

Directional pattern: Kidney

Operating principle: Pressure gradient with interference tube

Capsule type: Pre-polarised condenser, double diaphragm capsule

Frequency response: 20 Hz - 20 kHz

Frequency range +/- 2 dB at 30 cm (11.8 in): 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz

Nominal sensitivity +/- 2 dB at 1 kHz: 10 mV / Pa; -40 dB re. 1 V / Pa

Equivalent noise level, A-weighted: Typ. 20 dB (A) re. 20 uPa (max. 23 dB (A))

Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)

Distortion, THD <1%: 134 dB SPL RMS, 137 dB SPL peak

Dynamic range: Typ. 117 dB

Max. Sound pressure, THD 10%: 153 dB sound pressure peak

Switchable attenuator, filter etc.: 0 dB / -20 dB

Nominal output impedance: 200

Minimum load impedance: 2 k

Cable drive capacity: 100 m (328 ft)

Output balance principle: Impedance equalisation with Active Drive

Common mode rejection ratio (CMRR): > 60 dB

Power supply (for full power): P48 (phantom power)

Current consumption: 2.8 mA

Connection: XLR-3M. Pin 1: Shield, Pin 2: Signal + phase, Pin 3: - phase

Colour: Matt black

Weight: 164 g (5.8 oz)

Microphone diameter: 19 mm

Microphone length: 198 mm (7.8 in)

Maximum output voltage, RMS: > 5 V.

Polarity: + V on pin 2 for positive sound pressure

Temperature range: -40 ° C to 45 ° C (-40 ° F to 113 ° F)

Relative humidity (RH): Up to 90%

Awarded for its excellent direct microphone pickup and high SPL handling. It has been optimised for use on stage and has already been used on many stages and for recording sessions. They offer an unprecedented blend of clarity, fullness and dynamic range. The off-axis frequency response is linear, but in a narrower frequency bandwidth. This provides a higher isolation level and a better gain-to-feedback ratio. The microphone level is easier to control.


The foam design inside the heavy-duty transport box enables quick and easy replacement of the microphone/accessory inlays.

Properties

Characteristic: Cardioid
Directional microphone: No
Incl. Clamp: Yes
Low cut: No
Pad: No
Stereo pair: Yes
Type of construction: Capacitor
DPA-Microphones

Ansprechpartner:

DPA Microphones A/S
Kokkedal Industripark 101
DK-2980 Kokkedal

E-Mail: info-de@dpamicrophones.com
Web: https://www.dpamicrophones.com/de/

    Sicherheits- und Warnhinweise:

    Dieses Produkt enthält elektronische Bauteile und/oder wird mit elektrischer Energie betrieben.

    Bitte verwenden Sie es ausschließlich gemäß der Bedienungsanleitung und mit geeignetem Zubehör.

   ⚠️ Schützen Sie das Gerät vor Feuchtigkeit, extremen Temperaturen und mechanischer Beschädigung.

    Prüfen Sie Kabel, Netzteile und Anschlüsse regelmäßig auf sichtbare Schäden.

 

    ℹ️ Weitere sicherheitsrelevante Hinweise entnehmen Sie bitte der beiliegenden Bedienungsanleitung.

    ℹ️ Bei Fragen zur sicheren Verwendung wenden Sie sich gerne an unseren Kundenservice.

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.